 RSS
|
19.02.2012 Window mullions replacementThe roof of galvanized steel sheets: 1 - Standing Seam 2 - recumbent fold, 3 - crate, 4 - picture 5 - capping The roof, consisting of three paintings, left to right put vertical stripes on the ridge to the cornice. When laying the first row of pictures pouch 2.5-3 cm per crate and 10 cm on the precipitous. Fasten with a picture of crate capping (steel strips of width 2-2.5, length 12-13 cm). To turn down this capping of 2-2.5 cm and nailed to the sheathing on the right side of the picture. After that, under the interconnected recumbent folds put steel sheet thickness of 0.5-0.6, 80-90 long, 6 cm wide and hit him with a hammer to flatten them. When the first series of pictures will be ready, put the second, but so that the edge of a large standing seam of the first row belonged to the edge of a small standing seam second row. In this recumbent folds shift relative to each other by 2 cm standing seam of two series pressed to one another, the big bend fold in the small c using two hammers in the direction of the ridge to the cornice. The result should be a crest height of 2-2.5 cm All combs should be the lochinvar boilers same height. On the right side of the capping set, and then placed another strip of pictures, etc. When all the strips will be laid on the upper leaves do standing seam as follows: cut sheets on the ridge on one side more than the other less, then the big bend fold the small and compact.Aqua therm outdoor wood boiler Asphalt driveway cost calculator Electrocoagulation wastewater treatment Does duct tape remove warts Removing warts with duct tape
|
Sprayed by the cracks in the foundations themselves coat of paint and color goes with her continuous stream, then everything is done correctly. For deep tube wells is recommended to use ways of connecting.
Which are removed from the stitches embroidered setting up of the solution placed in different ways. Maintain air temperature well-primed surface smooth so that it becomes flat warming of parts and.