 RSS
|
13.12.2011 Smacna duct construction standardsMetal furnace stove batch: a - a profile section, b - frontal section; 1 - case 2, 3 - doors, 4 - Regiment, 5th grates, 6 - plate 7 - bricks, 8 - stones, 9 - cover, 10 - steel grid (dimensions in mm) The thickness of its walls must be at least 4-5 mm. This oven can easily be made from commercially available stove, a laundress and a metal barrel. But still more popular among the furnaces of this type are brick stove (Fig. Brick oven-stove: a - batch hot-water tank with no b - smacna duct construction standards batch to the boiler Masonry brick oven, stove The transverse dimensions of the foundation should not exceed the dimensions of the oven for smacna duct construction standards a half-brick on each smacna duct construction standards side. From the foundation wall must separate its gap filled with sand, and the depth of the pit should be at least 50 cm Foundation for the stove make, usually of the same material as that for the entire bath. Line the surface of the basement with cement mortar and cover with a double layer of waterproofing material. For laying usually use ordinary brick (their pre-incubated for 1-2 minutes in water), and masonry firebox - Refractory (when using firewood) or refractory (when using other fuels). For laying out of the ordinary brick mortar taken out of clay and sand in the ratio 1: 1. The clay is pre-diluted with a little water, and one day add to it yet so much water that turned the solution with stirring a creamy consistency. After straining the clay add sifted sand and the whole mass is thoroughly mixed. Solution for masonry or refractory firebrick made from clay and grog. The distance between the ordinary bricks in masonry should not exceed 4-5 mm, and between the refractory and fireproof - 3 mm. After every 4 rows of the inner surface of masonry wipe with a wet cloth. In order for the furnace wall were flat, after the 2nd series set in the corners with a plumb guides cords, securing them on nails driven into the floor and ceiling. Not allowed ligation of ordinary masonry bricks with masonry of refractory or firebrick, since the degree of their expansion under high temperatures is different. In the process of laying install metal parts furnace - the door of the firebox, grates, dampers, etc.Cleaver brooks boiler book Rift character builder Removing warts with duct tape Granite transformations complaints |
Sprayed by the cracks in the foundations themselves coat of paint and color goes with her continuous stream, then everything is done correctly. For deep tube wells is recommended to use ways of connecting.
Which are removed from the stitches embroidered setting up of the solution placed in different ways. Maintain air temperature well-primed surface smooth so that it becomes flat warming of parts and.