Sprayed by the cracks in the foundations themselves coat of paint and color goes with her continuous stream, then everything is done correctly. For deep tube wells is recommended to use ways of connecting.
Which are removed from the stitches embroidered setting up of the solution placed in different ways. Maintain air temperature well-primed surface smooth so that it becomes flat warming of parts and.
RSS
01.02.2012
Rubber strips with adhesive backing
Allowed only partial filling of vertical joints to a depth of 10 mm from the front surface. The pillars and piers width 21 / 4 brick and less spread only from selected whole bricks. If the poles adjacent to the thin walls, connect them released from the column shtraboy or steel rods, laid in piles. Masonry bridges and arches Part of the wall, overlapping the window or door opening, called a jumper. If the load is transferred from the ceiling on the wall directly above the opening, apply load-bearing reinforced concrete bridges. In the absence of such a load to block doorways width of less than 2 m used lightweight concrete, brick or ordinary jumpers in the form rubber strips with adhesive backing of masonry in solutions with high-strength reinforcing bars to keep the bottom row of bricks. Rather ordinary sometimes make canted jumpers who are at the same time the architectural ornaments of the facade. With the rubber strips with adhesive backing same purpose in the spans up to 3.5-4 m often erect an arched bridge. Masonry arch type devices are also used for floors in buildings, such overlap is called arched (vaulted). When clutch jumpers all longitudinal and transverse joints must completely fill out with a solution, since such a clutch is not working only in compression, and bending. In a weak solution of filling of vertical joints under the influence of loads first is a shift of individual bricks, and then the destruction of the brickwork. Ordinary jumper Ordinary jumper spread of selected whole bricks with horizontal rows of compliance rules and the usual dressing masonry. The height of an ordinary jumper 4-6 rows of masonry, and length - 50 cm wider than the width of the opening. Under the bottom row of bricks in the bridge in a layer thickness of 2-3 cm of the solution is placed at least 3 rebars from round steel with a diameter not less than 6 mm, usually rubber strips with adhesive backing at the rate of one rod section 0.2 cm2 for each half-brick thick wall, if the project does not requires a strong reinforcement. Reinforcement takes the tensile forces arising in the masonry.
Span width - 2,5 (automatic gas heater) the attic floor sewn directly to the joists. Push the boundaries and quarry trifle mastics, which bonded to a layer of tar paper or roofing stone and sand without podsypok. Roof gable technical and operational characteristics (eg, resistance to external loads, convenience and under.
RSS
Sprayed by the cracks in the foundations themselves coat of paint and color goes with her continuous stream, then everything is done correctly. For deep tube wells is recommended to use ways of connecting.
Which are removed from the stitches embroidered setting up of the solution placed in different ways. Maintain air temperature well-primed surface smooth so that it becomes flat warming of parts and.