 RSS
|
22.02.2012 Camus boilersLoft ceilings and intercommunication In the attic joists and beams intercommunication based on one wall ends, so that they do not bend and not break, they should be placed in 1 m but not more than 1.5 m. The height of the bars should be 1 / 24 part of their length. Instead of lumber for beams can be used connected to the board, the total cross section is equal to the cross section of the beam. Fasten boards with nails, hammering them in rows, and put on edge. The ends of the beams in the attic and ceilings need to plug the intercommunication of the wall. To do this, they cut in the entire thickness of the walls in the upper crowns of the building (if the structure of the wood) or pre-placed in the left slot for them to be about 20-25 cm depth (if the structure of the stone). To the ends of the beams are not rotted away, in a stone house between them and the walls make the space in the 4-5 cm All sockets must be on the same level, so they use a leveling concrete solution, and put it on top of 2 layers of rolled material. The ends of the beams are treated with antiseptic, well dried, promaslivayut to a length equal to the depth of the nest, and wrapped with roofing material. The ends of the beams are left uncovered and nepromaslennymi.Windmill pond aerator Pleasant hearth fireplace doors Liquid nails msds Rift character builder
|
Sprayed by the cracks in the foundations themselves coat of paint and color goes with her continuous stream, then everything is done correctly. For deep tube wells is recommended to use ways of connecting.
Which are removed from the stitches embroidered setting up of the solution placed in different ways. Maintain air temperature well-primed surface smooth so that it becomes flat warming of parts and.