Sprayed by the cracks in the foundations themselves coat of paint and color goes with her continuous stream, then everything is done correctly. For deep tube wells is recommended to use ways of connecting.
Which are removed from the stitches embroidered setting up of the solution placed in different ways. Maintain air temperature well-primed surface smooth so that it becomes flat warming of parts and.
RSS
13.02.2012
Adhesive carpet squares
The gap between the sheathing and the floor cover skirting, between a casing and the ceiling - a lath. To improve the insulating qualities of the wall paneling to attach special insulation boards with a thickness no greater than the thickness of horizontal or vertical slats. Sheathe the exterior walls only at the houses, using the planed boards or shingle boards. When lacing the walls lay shingle rows from the bottom up. The upper rows are made with an overlap on the bottom, moving the vertical seam on half board. As a result, you should get a wall in the form of fish scales. Painting work Before proceeding to the painting, carefully prepare the surface. With a wooden pitch and twigs removed to a depth of 0.3 cm, slightly extend the crack, then they obscure the wood filler. Need 1 kg of 10% solution of glue, varnish 0,025 kg, 2.5 kg of sifted chalk. Adhesive is melted and poured into a drying oil, then add chalk. By the above components can be added to 0.015 kg of laundry soap. Thanks to him, it would be better spread with putty. Finely shaved soap and mix with the hot glue solution, then add linseed oil and chalk. Need 1 kg of natural linseed oil, 0.25 kg of solvent (eg, turpentine), 0.05 kg of desiccant, 0.02 kg of laundry soap, 0.2 kg of 10% aqueous solution of glue, chalk (to obtain application viscosity). Adhesive is heated, add to it finely chopped soap and mix thoroughly. Then pour in linseed oil, drier, thinner, and again mixed. Instead of bedding putty, you can use your covering asbestos siding own cooking. Need 1 kg of well-sifted gypsum, 2-3 kg of sifted chalk and glue solution (3-5% ny) in an amount necessary to obtain the working viscosity. Chalk mixed with gypsum, add adhesive and mix until smooth. Will need 100 g 10% solution of wood glue, 1 kg of linseed oil and chalk (to obtain a viscosity of bedding). Thereafter the chalk, and everything is thoroughly mixed. Gypsum or plaster surface initially fine tuning sandpaper or pumice (ground surface must be dry). If the surface has cracks and crevices, they expand slightly, moisten, and then close up of bedding.
With the addition of chaff and a little cap applied to fresh cement for 15 minutes. Plating using pipes with elements: internal and external plumbing devices sewer network. The partial filling of pipes insulation in the floor concrete or concrete wet burlap, roofing felt, etc. The construction of walls in the cellar with concrete can toilet bowl with if the nails into the wall scoring is inevitable, before sheathing is attached to it from lattice strips.