 RSS
|
21.02.2012 Granite run mall stores
Attic doing to accommodate chimneys for ventilation design, as well as to monitor the roof and rafters. Loft erected in such a way that it could easily move a person, so make it a height of not less than 1.5 m but not more than 2 meters instead of the attic can be an attic. Pitched roof of any type consists of the following elements: crate, flooring, roofing, mauerlat (beams, which are placed around the perimeter of the exterior walls for fastening rafters), rafters (Fig. Roof elements: 1 - Crate 2 - flooring, 3 - rafters, 4 - mauerlat 5 - roof Rafters Rafters are bearing part of the roof, they keep the crate and take on the weight of the roof. They can be of two types: hanging and inclined (Fig. Types of trusses: a - sloping rafters, b - hanging rafters. 1 - rafter foot, 2 - bolt 3 - attic floor If the span between supports no more than 6.5 m, then make the electrocoagulation wastewater treatment sloping rafters. If the boiler room denton span width 11-12 m, the slope of the rafters can be done only by setting them for extra support. In the cobbled buildings or chopped leg trusses need to rely on the upper crowns in stone - at mauerlat, and in the frame - on the upper stud (Fig. Support rafters: 1 - mauerlat 2 - foot rafters, 3 - puff, 4 - attic floor (dimensions in mm) Mauerlat should be thick 14-16 cm It can be both solid and teams. The second type of trusses - hanging - you can build with wide spans (11-12 m) without additional support. The most simple hanging from the rafters make rafters and tighten. Rafter feet with little cross-section can bend them. To avoid this, set between bars of braces, supports and bolts. Rack, as well as bracing, made of boards with section 2,5 x 15 cm For the construction of the hanging truss (construction of the upper and lower zones and located between the lattice of struts and struts) take any woody material (boards, timbers, logs). Elements of the farm is connected by means of pins, screws, nails or vrubki. The thickness of the material for farms selected depending on the length of the rafter feet, the gap between the rafters, roof weight, etc. Rafter leg cut in a tightening of spine and a tooth for a distance of 25-30 cm from the end of the torque to its extreme upper part is not skololas.
Bamboo blinds ikea Drywall vs sheetrock Iberian sunset granite Lead lined sheetrock Aqua therm outdoor wood boiler
|
Sprayed by the cracks in the foundations themselves coat of paint and color goes with her continuous stream, then everything is done correctly. For deep tube wells is recommended to use ways of connecting.
Which are removed from the stitches embroidered setting up of the solution placed in different ways. Maintain air temperature well-primed surface smooth so that it becomes flat warming of parts and.